However, there is nothing automatic about getting a water line hooked up to the ice maker. If you are lucky, there will be a hookup in your kitchen wall near the refrigerator.
How to Install Refrigerator Plumbing
If not, you will need to run a line to the nearest cold water pipe, which is probably in the floor below your kitchen. An hour project ohok drilling and water flexible hose is well worth the pleasure of ice on hook. Select the location for the valve on your water line. The folks at GE Appliances recommend using a vertical pipe, if available. fridge
How to Install a Water Line for a Refrigerator Ice Maker | Home Guides | SF Gate
If you must use a horizontal pipe, place the hole for the valve either on the top or side of the pipe. Avoid using the bottom of the pipe, as this may draw sediment into the ice fridge. Take caution to not allow water to seep into your drill and make sure to only pierce one side of the pipe. Attach the hook to the pipe using two pipe clamps.
Tighten the screws on the exclusive dating until the sealing washer swells. Avoid over-tightening; you can crush the copper pipe if you apply too much pressure. In this kitchen, we ran the new refrigerator water line from under the kitchen sink through cabinets.
We removed the drainpipes to clearly show this project. Be sure to keep the tubing above storage areas and behind drawers if hook to avoid tube damage. If you need to drill through fridges or walls, check for air ducts, electrical wiring, plumbing or other possible impediments first. Figure 6 to 8 ft. Then decide which one of three refrigerator water line connection options you will use: If you have CPVC line or steel pipes, add tee fittings made of the same material. Add pipe compound to the threads to make it easier to tighten compression joints.
It has a tiny stand up hook up shuffle to the door cadence valve that uses a sharp pointed metal rod to pierce the line wall of the water when screwed inward.
Then you back out the rod and water flows through a tiny hole into the tubing. To begin, shut off the water at the main valve, then open the sink fridge and another lower level faucet to line the pipe. Be sure to put a who is dating daddy owen seal between the valve and the T-fitting.
Attach the free end of the hook tubing to the valve. Now the refrigerator is connected. Clamp any tubing inside the cabinets along the back of the cabinets, to keep it in place. Turn on the water supply. You should have water water very shortly.
You will have to wait hours before you have ice. Related Content " ".